86PO
S AVE THESE INSTRUCTIONS
(86PO) EASY SET POOL ENGLISH 7.5” X 10.3” PANTONE 295U 06/13/2013
English
Page 8
POOL SETUP (continued)
2
3
IMPORTANT
Properinationofthetopring.
The ambient temperatures of air and water have an effect on the internal pressure of the top ring. To
maintain a correct internal pressure, it is best to leave some room for expansion as the sun heats the
air inside the ring. During very hot weather, you must check to see whether it is necessary to release
some air. This is to avoid any possible damage to the ring.
In no event shall Intex, their authorized agents or employees be liable for damages (such as pin
holes) to the inatable top ring caused by negligence, ordinary wear and tear, abuse and
carelessness, or external forces.
YoumayhavepurchasedthispoolwiththeIntexKrystalClear™lterpump.Thepumphasits
ownseparatesetofinstallationinstructions.Firstassembleyourpoolunitandthensetupthelter
pump.
Estimatedassemblytime10~30minutes.(Notetheassemblytimeisonlyapproximateand
individualassemblyexperiencemayvary.)
1. Liner preparation
• Findaat,levellocationthatisfreeandclearofstones,branchesorothersharpobjectsthatmay
puncture the pool liner or cause injury.
• Openthecartoncontainingtheliner,etc.,verycarefullyasthiscartoncanbeusedtostorethepoolduring
the winter months or when not in use.
• Takeoutthegroundcloth(3) and spread it over the cleared area.
Then take out the liner (1) and spread it out over the ground cloth,
with the drain valve directed towards the draining area. Place the
drain valve away from the house.
IMPORTANT: Always set up the pool unit with at least 2
persons. Do not drag the liner across the ground as this can
cause liner damage and pool leakage (see drawing 2).
• Duringthesetupofthepoolliner,pointthehoseconnectionsor
openings in the direction of the electrical power source. The
outeredgeofthepoolshouldbewithinreachofthepump’s
electrical connection.
• Layoutthepool.Spreadouttheplainbluesidesandmakethe
pooloorassmoothaspossible(see drawing 2).
2. Ring ination
• Flipthetopringoutandcheckthatitisfullyoutsideofthewall
liningandfacingup.Inatetheringwithamanualairpump(see
drawing 3).Keepthetopringcenteredinthemiddleofthepool,
while doing this.
IMPORTANT: Prevent bursting by not using a high-pressure
pump, such as an air compressor. Do not over inate.
Preferably use an Intex manual ination hand pump
(not included).
3. Hose connectors
• Thefollowingappliestopoollinerswithhoseconnectors(16"(488cm)&belowpools).Ifthepoolwas
purchased withoutalterpump,inserttwoblackplugs (2)intotheblacklterpumpoutlets.Dothis
fromtheinsideofthepoolsothatwaterwillnotrunoutwhenllingit.
• Ifthepoolwaspurchased withalterpump,readtheKrystalClear™FilterPumpManualrstandthen
proceed to next installation step.
1
WATER
LEVEL
Level
FILLLINE
Comments to this Manuals